Filter
Top Products
Page 16 of 20 Intimidator™ Spot LED 350 User Manual (Rev. 6)
Master/Slave
Mode
The Master/Slave mode allows a single Intimidator™ Spot LED 350 unit (the “master”) to
control the actions of one or more Intimidator™ Spot LED 350
units (the “slaves”)
without the need of a DMX controller. The master unit will be set to operate in either
Automatic or Sound-Active mode, while the slave units will be set to operate in Slave
m
ode. Once set and connected, the slave units will operate in unison with the master
unit.
Configure the units as indicated below.
Slave units:
1. Press <MODE/ESC> repeatedly until SLAv shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to 001.
4. Connect the DMX input of the first slave unit to the DMX output of the master unit.
5. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in either Automatic or Sound-Active mode.
2. Make the master unit the first unit in the DMX daisy chain.
· Configure
all the slave units before connecting the master unit to the DMX
daisy chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller
may interfere with the signals from the
master unit.
· Do not connect more than 31 slave units to the master unit.
Reset Software
To reset the software on the Intimidator™ Spot LED 350, do the following:
1. Press <MODE/ESC> repeatedly until rESt shows on the display.
2. Press <ENTER>.
The product will reset all settings in the software to the default
factory settings.
Password
Channel
The Intimidator™ Spot LED 350 contains a password-
protected mode which allows you
to calibrate and troubleshoot any small issues you may have during normal operation.
In order to access this mode, do the following:
1. Press and hold <MODE/ESC> for at least 10 seconds.
2. Use the <UP> and <DOWN> buttons to enter the password: 2323.
3. Press <ENTER>.
In this mode there are several options for adjustment:
Parameter Programming Steps Description
Pan Adjust P128 Manually adjust the pan angle
Tilt Adjust t128 Manually adjust the tilt angle
Gobo Wheel Adjust G128 Manually adjust the gobo wheel
Color Wheel Adjust C128 Manually adjust the color wheel
Focus Adjust F128 Manually adjust the focus
Prism Adjust L000 Manually adjust the prism
Lamp Brightness Adjust d000 Manually adjust the starting
brightness of the lamp