Filter
Top Products
Intimidator™ Spot LED 350 User Manual (Rev. 6) Page 17 of 20
Changing
Gobos
To change the gobos in the Intimidator™ Spot LED 350
, do not remove the gobo wheel.
Simply:
1. Turn off and disconnect product from power outlet.
2. Place the product on a flat, level surface with the front facing up.
3. Access the gobo plate by
removing the cover on the moving head. By hand,
gently pry up the right side, then push right with the indented handles.
NOTE: If you expose the driver board, you are on the wrong side of the
head. Replace the cover immediately
and remove the cover on the
opposite side of the moving head.
4. Rotate the gobo wheel until the gobo that needs replacing is accessible.
5. Separate the g
obo holder assembly away from the gobo wheel by pushing it
forward and up. Be careful not to push the gobo out of the gobo plate.
6. Extract the gobo holder by pulling it backwards out of the product.
7. On a flat surface, remove the expansion ring that holds th
e gobo in place and
remove the gobo from the gobo plate.
8. Insert a new gobo and hold it in place with the expansion ring.
9. To re-
insert the new gobos, slide the tip of the gobo holder under the pressure
plate near the center of the gobo wheel.
10. Push the gobo
holder assembly inwards. DO NOT force the gobo holder into
the gobo wheel slot. Slightly move the holder from side-to-
side if needed to get
it to seat properly. If correctly installed, the bottom of the holder will be flush
with the gobo wheel.
11. Push cover back into position.
Gobo Replacement Diagram
Gobo Wheel Detail Views
Expansion Ring
Gobo Holder
Assembly
Gobo Holder Removal
Easy-access Panel
Gobo