Filter
Top Products
3. Setup 7 9/13/2010 2:33 PM
Mounting
Orientation
The LED PAR 56-24UVB
may be mounted in any position provided there is adequate room for
ventilation.
Rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical
Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. Use
a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm in size. When
rigging, consider routine maintenance and control panel access. Please see the following notes
on installation.
• Be sure to orient the gel frame release so that it is pointing up. Please see the diagram
below for a visual reference.
• If you intend to use the power link out with multiple fixtures, consider the length of each
power cable, and mount the fixtures close enough to one another to account for this.
• When aiming the fixtures, you may use the bracket adjustment knob. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
• Use the secondary bracket for floor standing applications.
• Always use safety cables.
Mounting
Bracket
Secondary bracket
(used primarily for
standing position)
Do not use a tool on
the bracket
adjustment knob
Aim the fixture with the
gel frame release
pointing up, (as shown
in this diagram)