Filter
Top Products
Eclipse™ RGB User Manual 10 12/20/2011
Hanging Clamp
Note!
Clamp is sold separately.
3. SETUP
AC Power
This product has an auto-ranging power supply that can accommodate a wide range of input
voltages. The only thing necessary to do before powering on the unit is to make sure the line
voltage you are applying is within the range of accepted voltages. This product will accommodate
between 100~240V AC 50/60 Hz. All products must be powered directly off a switched circuit and
cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100% switch.
Mounting
Orientation
This product may be mounted in any safe position, provided there is adequate room for ventilation.
Rigging
It is important never to obstruct the fan or vents pathway. Mount the product using, a suitable “C” or
“O” type clamp. Adjust the angle of the product by loosening both knobs and tilting the product.
After finding the desired position, retighten both knobs.
When selecting installation location, take into consideration access and routine maintenance.
Safety cables must always be used.
Never mount in places where the product will be exposed to rain, high humidity, extreme
temperature changes or restricted ventilation.