Filter
Top Products
ST-200 User Manual 3
Revision: 2004-11-02/11:23
BEFORE YOU BEGIN
What is included
¾ ST-200
¾ Power cord with plug
¾ 200w Xenon lamp (Installed)
¾ Warranty Card & Manual
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned to the factory, it is important that the fixture be returned in the original factory box
and packing.
Safety Instructions
• Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that
they also receive this instruction booklet.
• Always make sure that you are connecting to the proper voltage and that the line voltage you are
connecting to is not higher than that stated on decal or rear panel of the fixture.
• This product is intended for indoor use only!
• To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no
flammable materials close to the unit while operating.
• The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces. Be sure that no ventilation slots are blocked.
• Always disconnect from power source before servicing or replacing lamp or fuse and be sure to
replace with same lamp source.
• Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use
its carrying handles.
• Maximum ambient temperature is Ta: 40°. Do not operate fixture at temperatures higher than this.
• In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit
by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. Always use the same type spare parts.
• Don’t connect the device to a dimmer pack.
• Make sure power cord is never crimped or damaged.
• Never disconnect power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to lamp.
Caution! There are no user serviceable parts inside the unit. Do not any repairs yourself. In
the unlikely event your unit may require service, please contact CHAUVET.
Please read these instructions carefully, which
includes important information about the installation,
usa
g
e and maintenance?