Filter
Top Products
Setup
ST-200 User Manual 6
Revision: 2004-11-02/11:23
Figure 1 - Hanging Bracket
Note!
Clamp is sold separatel
y
.
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation. It is also
possible to stand this fixture using the removable feet provided.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding
the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
• Safety cables should always be used.
• Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
Using a Color Gel
The ST-200 is equipped with a detachable clear front cover that doubles as a gel holder as illustrated
below.
1) Open the clear lamp cover by removing the thumbscrew.
2) Cut a piece of gel filter to match the size of the cover or slightly
larger. The size of the gel used in the illustration was a 6.5” by
6.5”.
3) Lay the gel over the opening, close cover and replace the
thumbscrew securely.