Filter
Top Products
Power
Your product is equipped with switch-selectable AC power
setting.
Slide switch up or down
depending on your line voltage.
Warning! Verify that the power select switch on your unit
matches the line voltage applied. All fixtures must
be connected to circuits with a suitable Earth
Ground.
• To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture’s specifications chart.
• A fixture’s listed current rating is its average curren
t draw under normal conditions.
• All fixtures must be powered directly off a switched
circuit and cannot be run off a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100%
switch.
• Before applying power to a fixture, check that the source voltage ma
tches the fixture’s requirement.
• All fixtures must be connected to circuits w
ith a suitable Earth Ground.
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
Hanging Clamp
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a s
uitable “C” or “O” type clamp. Adjust the angle of t
fixture by loosening both knobs and tilting the fixture. After findi
the desired position, retighten both knobs.
he
ng
• When selecting installation location, take into consideration lamp
replacement access and routine
maintenance.
• Safety cables should always be used.
• Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
Note!
Clamp is sold separatel
y
.
TFX-64CM User Manual 7 Revision: 2006-11-30/17:23