Filter
Top Products
Page 4SKU 38437
Unpacking
When unpacking, check to make sure the following parts are included. If any parts are
missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
ACCESSORIES
Assorted biscuits: 0, 10, 20 gauge
Carbon motor brush set
4 mm Hex wrench
Arbor wrench
Glue bottle
Operation
Part Numbers Used Below Refer to the Parts List
and Assembly Drawings On Pages 8 and 9.
Attaching Dust Bag
For efficient dust pickup, empty bag frequently.
1. To install Dust Bag (45), slide bag connector onto dust porthole on Joiner (43) until it
snaps into place.
2. To remove, pull release tab on right side of bag connector and slide bag off.
3. To empty Dust Bag, remove Bag Clamp (63) from power cord and slide plastic clip off
large end of bag. Do this over a trash can.
Adjusting Front Fence
1. To remove Adjustable Front Fence (44), remove the two Lock Knobs (59) and slide the
retaining Bolts (57) out of the front fence assembly, and remove fence.
2. To attach the Adjustable Front Fence (44), insert the two fence bolts through the two
holes in front of the fence, and through the Joiner (43).
Note: The lower holes in front of Joiner contain nuts which may be used
to fasten a fixed auxiliary fence accessory, but are not used with the Ad-
justable Front Fence.
3. To reposition Adjustable Front Fence (44), loosen the two Lock Knobs (59), slide the
fence up or down to desired position. Retighten Lock Knobs. The front of the base
plate has a height scale to help position the fence.