Filter
Top Products
Page 17SKU 40315 For technical questions, please call 1-800-444-3353.
(not included, sold separately),
making sure to install Blade
according to indicated rotation
direction on Blade.
F. Replace the Outside Flange (7)
and Nut (4). Use the Spanner
(59) to hold the Outside Flange
(7) while you tighten the Nut
(4) securely with the Nut Driver
(60). Do not overtighten.
G. Replace the Front Cover (1),
Rear Blade Cover (58), Screws
(2), Washers (3), and Tray (17)
in the reverse order of removal.
8. To clean: Wipe with a damp cloth,
vacuum or use compressed air. Do
not use solvents.
9. When storing: Store the Tile
Saw in a safe, clean, dry, location
out of reach of children and other
unauthorized people.
10. CAUTION! All maintenance, service,
or repairs not listed in this manual are
only to be attempted by a qualied
service technician..
Troubleshooting
Problem Possible Causes Likely Solutions
Tool will not start
1. No power at outlet.
2. Cord not connected.
1. Check power at outlet.
2. Check that cord is plugged in.
Blade spins slowly
1. Arbor shaft binding
2. Motor brushes worn
1. Check shaft for free spinning.
2. Replace brushes.
Excessive vibration 1. Bent or off-balance blade.
2. Bent Arbor Shaft.
1. Replace blade with new one.
2. Check shaft for run-out.
Running hot;
excess dust or
chips or not cutting
clean
1. Water ow problem.
2. Not cutting tile cleanly.
3. Running with hot/warm water.
1. Check water level; ll to proper level.
2. Turn off Saw; let cool and turn back on,
slowing feed rate .
3. Always run with cold water.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.