Filter
Top Products
SKU 45338 For technical questions, please call 1-800-444-3353. Page 9
SPECIFICATIONS
Electrical Requirements 120 V~ / 60 Hz / 6.3 A
Motor No Load Speed 0-2800 RPM
Chuck Capacity 3/64 to 1/2”, plus key
chuck
Chuck Thread 1/2" - 20 UNF
E194601
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
Housing (29)
Auxiliary Handle (501)
Chuck (2)
Depth Gauge (502)
Wing Nut
Figure D
1. Insert the Auxiliary Handle (501) over
the Housing (29) until it rests behind
the Chuck (2). When required for
exact depth drilling, insert the Depth
Gauge (502) into the Auxiliary Handle
clamp. See Figure D.
Turn the Forward Handle for left or 2.
right-handed use, then securely tight-
en the wing nut until Auxiliary Handle
cannot move.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.