Filter
Top Products
SKU 66127 For technical questions, please call 1-800-444-3353. Page 8
Once the Battery is charged, discon-6.
nect the Charger from the electrical
outlet and the Charger from the Bat-
tery Pack. Connect the Battery to the
base of the Drill.
Installing a Drill Bit
Turn the Chuck (4) of the Drill coun-1.
wide enough to receive a 3/8” bit.
Place the bit of a driver or drill (not 2.
Chuck clockwise until secure.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Forward/Reverse
Switch of the tool to its center,
locked position and remove
the Battery before performing
any inspection, maintenance,
or cleaning procedures.
Work Piece and Work Area Set Up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
Secure loose work pieces using a 2.
vise or clamps (not included) to pre-
vent movement while working.
-3.
4. Warning, to prevent serious
injury
hidden utility lines before drilling or
driving screws.
General Operating Instructions
Mark the position of the hole to be 1.
drilled with a center punch to prevent
the Drill from “walking”.
Attach the Battery to the bottom of 2.
the handle, it will click when it locks
into place.
Move the Forward/Reverse Switch to 3.
the desired position.
Turn the Torque Selector to the cor-4.
rect torque setting. Do not change
the torque setting while the drill is
moving.
Pull the Trigger to start the Drill. Al-5.
low the drill to come up to full speed,
before, applying it to the work sur-
face.
6.
as torque will cause the tool to twist.
When drilling in light gauge metal or 7.
wood, place a wooden block behind
the material to prevent damage to the
cutting oil when drilling iron or steel.
Use a coolant when drilling nonfer-
rous metals such as copper, brass, or
aluminum.
To drill holes parallel to the ground, 8.
make sure the bubble stays between