Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. SKU 67707
Retainer (2)
Scraper Blade (501) Spindle (3)
Cap Screw (1)
Figure 4
Note: When attaching the angled Cutting
Blade (502) or Scraper Blade (501),
orient the accessory as shown in Figure
4 above, so the Cap Screw (1) will be out
of the way when working.
Replace the Retainer and Cap Screw c.
while holding the accessory. Hold the
Spindle with the wrench, then tighten
securely using the Hex Wrench.
CAUTION: Make sure that the accessory is
held securely in place by the four pins
on the Spindle as you tighten the Cap
Screw.
Note:
Pad (503) to the tool, then align a sheet
of Sandpaper (504) over the pad and
press into place.
General Operating Instructions
Secure loose work pieces using a vise 1.
or clamps (not included) to prevent
movement while working.
Install desired accessory.2.
OFF
Figure 5
Power Switch
(26)
3. Make sure the Power Switch (26) is OFF.
Tool Body
Battery Pack
Battery
Button (31)
Figure 6
4. Once the Battery Pack is fully charged,
slide it into the back of housing until it
clicks into place.
Note:
housing only one way. Match up the
shape of the tool with the shape of the
housing opening. The Battery Pack
should slide easily into the housing. Do
not force it into the Tool.