Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. SKU 67845
To set the Impact Anvil (6) to turn
forward (clockwise), press the right
until it clicks into place.
To set the Impact Anvil (6) to turn in
Reverse (counterclockwise), press the
(26) until it clicks into place.
CAUTION: To prevent possible gear damage,
always allow the Impact Anvil (6) to come
to a complete stop before changing the
direction of rotation.
Basic Operation
Charge the Battery Pack, but do not 1.
attach it to the Impact Wrench yet.
2.
to lock the Trigger (27).
Slide the desired socket (sold separately) 3.
onto the Impact Anvil (6).
Figure 5
Flange
Impact Wrench
Battery Pack (35)
4.
Impact Wrench with the slots on the
Battery Pack (35), and slide the Impact
Wrench onto the Battery Pack.
Set the desired direction of the Impact 5.
(26).
Position the socket over the fastener.6.
7.
and the top of the Housing (24 & 28)
Trigger (27).
Note: This tool has a variable speed and
tightly will increase the speed and torque
of the tool.
After tightening a fastener, check the
8.
torque with a torque wrench to make
sure the fastener is secure.
9.
To remove the Battery Pack (35), press 10.
in on both buttons on the side of the
Battery Pack and slide the Impact
Wrench off of the Battery Pack.
Store the tool and Battery Pack (35) 11.
in it’s Storage Case (38), away from
children.
“Breaking Loose” Fasteners
To loosen a fastener which has become
Spray silicon or another appropriate 1.
lubricant (sold separately) on the
minutes.
Position the socket over the fastener, 2.
then operate the Impact Wrench for short
other direction to loosen the bolt. Be
sure to let the Impact Anvil (6) come to
a compete stop, before changing the
direction of rotation.