Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 67845
Charging the Battery Pack
Figure 2
Charger (36)
Adapter (37)
Flanges
1. Plug the Adapter (37) into a 120V wall
outlet.
Charger (36)Battery Pack (35)
Flange
Figure 3
2.
with the slots on the Battery Pack (35)
and slide the Charger onto the Battery
Pack.
Figure 4
Charger (36)
Adapter (37)
Battery Pack (35)
Adapter
Cord
3. Plug the Adapter cord into the Charger.
The light on the Charger will turn on,
indicating that the Battery Pack is
Charging.
4.
the Adapter from the wall and the
Charger, and remove the Charger from
the Battery Pack.
Allow the components to cool if they
5.
are warm or hot to the touch. Store the
Adapter and Charger in the Storage
Case (38).
CAUTION: Do not leave the Battery Pack
charging for more than 5 hours or the
Battery Pack may become damaged.
Note: Initial charge and recharging is
approximately the same amount of time.
Work Piece and Work Area Set Up
Designate a work area that is clean and 1.
access by children or pets to prevent
distraction and injury.
Secure loose work pieces using a vise 2.
or clamps (not included) to prevent
movement while working.
There must not be objects, such as utility 3.
while working.
General Operating Instructions
Only use sockets designed for
impact wrench use.
Do not use sockets with drives smaller
than 1/2”. You may use impact socket
adapters to use impact sockets with
drives greater than 1/2”.
Do not exceed recommended bolt
capacity of 1/2”
Only use socket extensions
designed for impact use.
To lock the Trigger (27), center the
tool.