Filter
Top Products
Page 6 For technical questions, please call 1-800-444-3353. SKU 68104
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION:
Release the Trigger and unplug the tool from its
electrical outlet before performing any inspection,
maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED,
DAMAGED, OR REMOVED. Moving guards
must move freely and close instantly.
To Remove or Install a Cut-Off Wheel
1. Raise the Saw if it is locked down by pushing
down on it and pulling out the Lock Ball (21).
2. Open the Movable Guard (40) and tighten the
Bolt (39) to secure it while working on the Wheel.
3. Push in the Spindle Lock Pin towards the
Fixed Guard as shown in Figure F. Rotate the
wheel until the Lock Pin slides into place.
Figure F: Spindle Lock Pin
Spindle
Lock Pin
(61)
4. While continuing to hold down the Spindle Lock Pin,
use the Wrench (92) to remove the Arbor Bolt (41).
Figure G: Removing Cut-off Wheel
Spindle Lock
Pin (61)
Wrench
(92)
Cut-off
Wheel (44)
Arbor
Bolt (41)
5. Remove the Arbor Bolt (41), Arbor Washer (42),
Outer Flange (43), and Cut-off Wheel (44).
Figure H: Removing Wheel
Arbor
Bolt (41)
Arbor
Washer (42)
Outer
Flange (43)
Cut-off
Wheel (44)