Filter
Top Products
SKU 8878 For technical questions, please call 1-800-444-3353. Page 8
OPERATION
Note:
Stud Electrode
(23)
Electrode Assembly (26)
Trigger (17)
FIGURE 1
Circuit Breaker
Reset (20)
For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 12.
Caution: Always make sure the power cord to the Stud Welder is unplugged from its
electrical outlet prior to assembling or making any adjustments to the tool.
Note: Before trying to pull a dent out of your own vehicle, it is recommended that you
rst practice the procedure on a piece of scrap metal.
Welding the stud
On the location you are going to weld, and in a area as large as the Electrode
Assembly (26) surrounding it, clean the surface down to the metal (no paint).
The entire Electrode Assembly (26) needs to evenly contact the surface without
interference to weld properly.
Insert a Stud (32) into the hole in the Stud Electrode (23). See FIGURE 2.
Plug the Cord (16) into an outlet ca-
pable of handling a 20 amp load.
1.
2.
3.
FIGURE 2
Stud (32)
Metal
Surface
FIGURE 2
Stud (32)
Metal
Surface