Filter
Top Products
Page 10For technical questions, please call 1-800-444-3353.SKU 90045
off the Belt Sander.
(See Figures A and B.)
To Attach The Dust Bag:
DUST BAG (69)
Figure C
To attach the Dust Bag (69), simply clip
the opening of the Dust Bag onto the
Dust Port located on the Left Housing
(18). (See Figure C.)
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Trigger of the tool off
and unplug the tool from its
electrical outlet before adjusting
tool or installing accessories.
To start the Belt Sander, depress the 1.
Trigger (66). To stop the tool, release
pressure on the Trigger. (See Figure B.)
To lock the Trigger (66) in the 2. “ON”
position for continuous operation,
depress the Trigger and push in on the
Switch Lock. The tool will continue to
run. To turn off the tool, squeeze and
release the Trigger once.
(See Figure B.)
WARNING! 3. Prior to using the Belt
Sander (each time), make sure the
Switch Lock mechanism is working
properly. Release the Switch Lock
mechanism before disconnecting the Belt
Sander from its electrical outlet. Failure
to do so will cause the tool to start
immediately the next time it is plugged
into an electrical outlet, resulting in
possible injury or property damage.
Work Piece and Work Area Set Up
Designate a work area that is clean and 1.
access by children or pets to prevent
distraction and injury.
Route the power cord along a safe 2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
Secure loose work pieces using a vise 3.
or clamps (not included) to prevent
movement while working.
There must not be objects, such as utility 4.
lines, nearby that will present a hazard
while working.
Make sure the workpiece is free from 5.
nails and any other foreign objects which
could damage the Sanding Belt (46).
General Operating Instructions
Make sure the Trigger is released, 1.
then plug the Power Cord (14) into the
nearest 120 volt, grounded, electrical
outlet.