Page 11For technical questions, please call 1-800-444-3353.SKU 93431
Attaching Sandpaper to the Backing Pad
Backing
Pad (23)
Switch
(15)
The Sanding Disc is attached by Hook
Sanding Disc on the Backing Pad lining
up the 8 holes so that the dust can be
collected into the Dust Bag.
Work Piece and Work Area Set Up
Designate a work area that is clean and 1.
access by children or pets to prevent
Route the power cord along a safe 2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
Secure loose work pieces using a vise 3.
or clamps (not included) to prevent
movement while working.
4.
nearby that will present a hazard while
working. Make sure the wood you are
sanding does not have any nails or
metal of any kind in it, or you will ruin
the sandpaper and damage the Backing
Pad.
You must use personal safety equipment 5.
approved eye and hearing protection, as
well as heavy work gloves.
Before beginning work, provide for 6.
surface.
General Operating Instructions
Turn on the Sander using the Switch.1.
Run the Sander for a few seconds before 2.
contacting the workpiece.
Contact the workpiece with minimal 3.
pressure. If the Sander is not removing
enough material, try a grittier piece of
sandpaper. If you want to remove a lot
of material fast, use a belt sander.
Note: All orbital sanders leave sanding marks
on the workpiece. To minimize sanding
marks, always try to sand with the grain
of the wood.
Occasionally check the sandpaper 4.
for tears, wear, or fraying. Replace if
necessary.
5.
Switch.
Allow the tool to come to a complete stop 6.
before setting it down.
To prevent accidents, turn off the tool 7.
and disconnect its power supply after
use. Clean, then store the tool indoors
out of children’s reach.