Filter
Top Products
Page 13SKUs
94596 &
94896
For technical questions, please call 1-800-444-3353.
Blades. A 1/4 turn of the Lubricating Unit Knob will provide adequate lubrication
for several cuts.
Saw Blades: The Saw Blades should always be kept clean, sharp, and properly
installed in the Twin Cutter Saw. Using dull Saw Blades will place an excessive
load on the Saw and increases the danger of kickback. It is recommended to keep
extra Saw Blades on hand so sharp Saw Blades are always available.
To install the Saw Blades:
Unplug the Twin Cutter Saw from its electrical outlet.
To avoid accidental cuts, make sure to wear heavy duty work gloves while in-
stalling the Saw Blades.
FIGURE F
“INNER”
“OUTER” “OUTER”
PIN
Lay the Twin Cutter Saw down with its Blade Lock Nut pointing upward.
(See Figure F, above.)
Open the Lower Guard.
Place the Saw Blade marked “INNER” onto the Flange of the Gear Box with
the word “INNER” clearly visible. Then, align the holes in the Saw Blade with
the Pins on the Flange and securely fit the Saw Blade on the Flange.
Place the Saw Blade marked “OUTER” onto the Arbor Adapter with the word
“OUTER” clearly visible. Then, thread (do not tighten) the Blade Lock Nut onto
the Flange of the Gear Box.
Turn the Saw Blades so that the holes in both Blades are aligned.
Insert the Pin that is attached to the Wrench into the aligned holes in the Saw
Blades.
Using the Wrench, tighten the Blade Lock Nut clockwise. Do not tighten ex-
cessively. Then, remove the Pin from the Saw Blades. This will allow the Saw
Blades to turn freely.
Turn the Saw Blades with your gloved hand to ensure the Saw Blades easily
turn in opposite directions.
6.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.