Filter
Top Products
SKU 99702 For technical questions, please call 1-800-444-3353. Page 16
Troubleshooting
Problem Possible Causes Likely Solutions
Sprayer will not
start
No power at outlet.1.
Cord not connected.2.
Sprayer turned off under 3.
pressure.
Check power at outlet.1.
Check that cord is plugged in.2.
Turn pressure control knob to maximum, or 3.
PRIME/SPRAY knob to PRIME.
Sprayer will not
draw paint
Sprayer has lost prime.1.
Paint level too low in container.2.
Suction set clogged.3.
Suction tube loose at inlet.4.
Prime sprayer again.1.
Fill paint container.2.
Clean suction Set.3.
Tighten Suction tube connections.4.
Pressure drops
when trigger pulled
Spray tip worn.1.
Suction set screen clogged.2.
3.
Paint too heavy of coarse.4.
Replace spray tip.1.
Clean suction set screen.2.
3.
Strain and/or thin paint.4.
Paint runs
excessively
Paint too diluted.1.
Spray adjustment wrong.2.
Gun movement too slow.3.
Too close to surface.4.
Add undiluted paint to thicken.1.
Decrease pressure.2.
Increase speed of stroke.3.
Move gun back from surface.4.
Paint coverage
poor
Paint not diluted enough.1.
Paint is grainy.2.
Dilute paint more.1.
Filter paint.2.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT