Filter
Top Products
interface GigabitEthernet1/1/3
description ESXi Trunk
switchport trunk encapsulation dot1q
switchport mode trunk
end
Complete these steps:
Create two separate virtual switches in order to map to the virtual controller Service and Data Port.
Go to ESX > Configuration > Networking, and click Add Networking.
1.
Select Virtual Machine, and click Next.2.
Create a vSwitch and assign a physical NIC in order to connect the vWLC service port. The service
port does not have to be connected to any part of the network (typically disconnected/unused). As a
result, any NIC (even disconnected) can be used for this vSwitch.
3.
Click Next.4.
Provide a label (in this example, vWLC Service Port).5.
Select None (0) for VLAN ID as the service port is typically an access port.6.