Filter
Top Products
1-4
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02
Chapter 1 Basic Router Configuration
Information Needed for Configuration
interface FastEthernet8
no ip address
shutdown
!
interface FastEthernet9
no ip address
shutdown
!
interface Vlan1
no ip address
!
ip classless
!
no ip http server
no ip http secure-server
!
control-plane
!
line con 0
line aux 0
line vty 0 4
!
no scheduler allocate
end
Information Needed for Configuration
You need to gather some or all of the following information, depending on your planned network
scenario, prior to configuring your network
• If you are setting up an Internet connection, gather the following information:
–
Point-to-Point Protocol (PPP) client name that is assigned as your login name
–
PPP authentication type: Challenge Handshake Authentication Protocol (CHAP) or Password
Authentication Protocol (PAP)
–
PPP password to access your Internet service provider (ISP) account
–
DNS server IP address and default gateways
• If you are setting up a connection to a corporate network, you and the network administrator must
generate and share the following information for the WAN interfaces of the routers:
–
PPP authentication type: CHAP or PAP
–
PPP client name to access the router
–
PPP password to access the router
• If you are setting up IP routing:
–
Generate the addressing scheme for your IP network.
–
Determine the IP routing parameter information, including IP address, and ATM permanent
virtual circuits (PVCs). These PVC parameters are typically virtual path identifier (VPI), virtual
circuit identifier (VCI), and traffic shaping parameters.
–
Determine the number of PVCs that your service provider has given you, along with their VPIs
and VCIs.
–
For each PVC determine the type of AAL5 encapsulation supported. It can be one of the
following: