Filter
Top Products
B-7
Multiprocessor WAN Application Module User Guide
OL-7469-04
Appendix B Troubleshooting
MWAM System Error Messages
Error Message %MWAM_FILESYSTEM-3-FC_INVALID_DIR_REQ: Cannot read or write complete
%s file system.
Explanation
A CLI command attempted to copy or overwrite the full file system.
Recommended Action Copy from or to an individual file.
Error Message %MWAM_FILESYSTEM-3-FC_DIR_IS_FULL: Cannot add %s to file system,
directory is full.
Explanation
The file system directory holds a limited number of entries, and an attempt was made to
add a new file when the directory was already full. This can happen even when the file system still
contains free space.
Recommended Action Delete an existing file or FORMAT the file system.
Error Message %MWAM_FILESYSTEM-6-BOOTFLASH_BUSY: Cannot access bootflash,
filesystem is busy
Explanation
The MWAM bootflash does not support reading and writing at the same time. The
message means that bootflash is being accessed by some other operation, like copy, dir, format or
squeeze.
Recommended Action Try the bootflash operation again after other operations have completed.
Flash Error Messages
Error Message %MWAM_FLASH-3-ERR: "%s"
Explanation
An error occurred while programming/erasing the BootFlash
Recommended Action Copy the error message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error using the Output Interpreter
“OUTPUT_INTERPRETER.” Also perform a search of the Bug Toolkit “BUG_TOOLKIT.” If you
still require assistance, open a case with the Technical Assistance Center via the Internet
“TAC_CASE_OPEN,” or contact your Cisco technical support representative and provide the
representative with the gathered information.
Error Message %MWAM_FLASH-3-OTHER_CPU_RELOAD: "%s"
Explanation
The other CPU within this complex is reloading, flash programming operation can not
proceed.
Recommended Action Wait for the system to complete the reload operation.