Filter
Top Products
EN
ENGLISH
-10-
Clarke
®
American Sanders
Operator's Manual (EN) - Floorcrafter
Machine Set-Up (Cont)
7. Install a new abrasive belt by sliding the abrasive
over the tension roller and contact wheel.
(See figure 12)
8. Rotate the release lever backward to tighten the
abrasive belt.
CAUTION:
Do not force the release lever.
Doing so can damage the track-
ing mechanism and cause the
abrasive belt to mis-track.
9. Depending on the model, the control switch is
found on either the operationg handle or on the
motor. Verify that the control switch is set to
"OFF". See the marking on the switch.
10. Connect the electrical cord. On certain models,
the connection must be twisted clockwise to
lock.
11. Jog (turn on momentarily - test operation) the
control switch while observing the belt tracking.
Follow the procedures outlined in the "Sander
Adjustment Procedures" on page 16 to correct
the belt tracking. There is also a label on the
inside of the access door that outlines the belt
adjustment.
12. Close the access door. Place the end of the
draw latch over the keeper on the access door
and push the draw latch flat against the main-
frame to secure.
Figure 12