Filter
Top Products
EN
ENGLISH
Clarke
®
American Sanders
Operator's Manual (EN) - Floorcrafter - 15 -
Sander Adjustment Procedures
DANGER: Electrocution could occur if main-
tenance and repairs are performed
on a unit that is not properly dis-
connected from the power source.
Disconnect the power supply be-
fore attempting any maintenance
or service.
DANGER: Moving parts of this machine can
cause serious injury and/or dam-
age. Keep hands, feet and loose
clothing away from all moving parts
of the sander.
The following information provides details on how to
adjust different features/controls of the sander.
Dust Shoe
To adjust the dust shoe follow this procedure:
1. Disconnect machine from power supply.
2. Loosen the three screws fastening the dust shoe
to the chassis.
3. Adjust the dust shoe down to reduce clearance.
4. Adjust the dust shoe up to increase clearance.
5. Align the dust shoe to the chassis and tighten
screws. (See figure 15)
Sanding Pressure
There are three pressure settings to select from:
heavy, medium and light. The lower the position the
heavier the setting. To change settings, raise the
lever and place in desired position. (See figure 16)
Leveling the Drum
CAUTION: The belt tracking maybe adversely
effected if machine is operated
unleveled.
The machine is leveled at the factory set and no
adjustments should be necessary. After any mainte-
nance is performed to the carriage system, the pointer
on the leveling bracket must be returned to original mark
(See figure 17).
If it is necessary to reset level after replacing wheels
follow this procedure:
1. Lower the contact wheel to the floor.
Figure 17
Figure 15
Figure 16