Filter
Top Products
Model Staple Size
6000 1/4” - 3/8”
6100 1/4” - 1/2”
6200 3/8” - 9/16”
3
*Arrow
®
T-50
®
are registered trademarks of Arrow
Fastener Company.
Using Your Cobra
™
Hammer
Tacker
Selecting the Right Staple:
To maximize performance,
your Cobra
™
hammer tacker has
been designed to work with
genuine Cobra
™
brand heavy
duty staples in various lengths
from 1/4 inch to 9/16 inch (see
chart for what size staple fits each
Hammer Tacker model).
Cobra
™
hammer tackers are
also compatible with other brands
of heavy duty narrow crown
staples such as Powershot
®
and
Arrow
®
T-50
®
*brand heavy duty
staples.
Selecting the Right Staple Length:
As a general guideline, when
stapling into wood, allow for leg
penetration of approximately 3/16"
to 1/4”.
For additional tips on selecting
the right staple length for specific
applications, refer to the Staple
Selection Chart on page 5 of
this Instruction Manual.
Insert a strip of Cobra™ staples
into the staple chamber by sliding
a staple strip over guide track in
staple chamber (Fig. 3).
Insert the feeder strip into the
staple chamber by pushing in
and down to latch hook into the
locking position (Fig 4).
Loading Instructions (Fig.
1, 2, 3, 4)
Push staple chamber lock into
the staple chamber and lift up to
unhook the latch. (Fig. 1). (For
Model 6100 push down to
unhook)
Once lock is unhooked, pull the
feeder strip out from the staple
chamber (Fig. 2).
Chamber Cleaning
Instructions for Model
6000, 6200 (Fig. 5,6,7)
Remove the feeder strip as
indicated in the loading
instruction section.
Remove all staples.
Compress the forward assembly
of the hammer tacker with one
hand while removing the
connecting pin with the other
hand (Fig 5.).
Pull the staple chamber forward
and out for inspection and
cleaning purposes. (Fig. 6).