Filter
Top Products
Chapter 6 - Basic Configuration Guide 23
TB: Use configure and set the Mode and ConnectMode keywords in
the Link Config WAN 1 section.
Suggested for Dedicated/Leased Line Operation
Dedicated line operation generally does not require additional parame-
ters for operation.
Required for Dial-On-Demand Operation
This mode of operation is only supported on the WAN 1 RS-232 inter-
face. Incoming dial-on-demand operation requires only slightly more
information than dedicated line setup. Outgoing dial-on-demand
requires additional information (see the suggested settings below).
• Set dial-up connection
• Set PPP connection
• Set to allow dial-in and/or dial-out
CV: Use the Link Configuration: WAN 1.
TB: Use configure and set the Mode, ConnectMode, DialIn and/or
DialOut keywords in the Link Config WAN 1 section.
Suggested for Dial-On-Demand Operation
This mode of operation is only supported on the WAN 1 RS-232 inter-
face. Outgoing dial-on-demand requires some additional information.
• Create dial-out script
• Set dialing method
• Set dial-out script to be used
• Set inactivity time
CV: Use the Link Configuration: WAN 1 Dialog Box to set the dialing
method and to select a chat script (once you have created one).
Use the WAN Chat Scripts Dialog Box (under Global/WAN Chat
Scripts) to create your chat script.
TB: Use configure and then set the Dialing, DialOutScript,and
DropInact keywords in the Link Config WAN 1 section. Use
edit config and create a Chat section to contain your dialing
script.