Filter
Top Products
22 23
22 23
7. Tighten the lock nut (6).
8. When the blade is exactly 90
0
(0
0
) to the table, loosen the bevel
indicator screw (9) using a Phillips
screwdriver.
9. Adjust the bevel indicator (10) to
the “0” mark on the bevel scale and
retighten the indicator screw (9).
10. Attach the blade guard foot (1)
using the T-wrench
, so the foot
rests flat against the table and
tighten. (Fig. Q)
NOTE: Avoid setting the edge of the
table against the top of the motor,
which could cause noise when the saw
is running.
Fig. Q
Fig. R
BLADE GUARD FOOT ADJUSTMENT
(FIG. S)
NOTE: User must keep constant
downward pressure on workpiece when
cutting. The blade guard foot is not
designed to hold down the workpiece,
but is rather to help prevent the
workpiece from lifting up excessively.
When cutting at angles, the table guard
foot (1) should be adjusted so it is
parallel to the table and rests flat above
the workpiece.
1. To adjust, loosen the screw (2), tilt
the foot so it is parallel to table and
tighten the screw.
2. Loosen the
blade guard foot lock
knob (3) to raise or lower the foot
until it rests slightly above the
workpiece. Tighten blade guard foot
lock knob.
NOTE: To remove the blade guard foot
(1), loosen the hex screw (2) by using
the supplied T-wrench to turn the screw
counterclockwise.
Fig. S
1
2
5
8
9
10
3
4
7
6 1
2
3
4