Filter
Top Products
8 9
8 9
7. YOUR SCROLL SAW MUST
BE SECURELY FASTENED
to
a stand or workbench. If there
is any tendency for the stand
or workbench to move during
operation, the stand or workbench
MUST be fastened to the floor.
8. THIS SCROLL SAW is intended for
indoor use only.
9. TENSION BLADE PROPERLY
before starting the saw. Recheck
and adjust tension as needed.
10. BLADE TEETH MUST POINT
downward toward the table.
11. TABLE MUST BE CLEARED of all
debris before operating saw. Do not
perform lay out, set up or assemble
work on the table when the saw is
in operation.
12. TO PREVENT INJURIES, avoid
awkward hand or finger positions,
where a sudden slip could cause a
hand to move into the blade when
operating the saw.
13. HOLD WORKPIECE FIRMLY
against the table top.
14. NEVER CUT MATERIAL that is too
small to be held safely.
15. DO NOT USE dull or bent blades.
SCROLL SAW SAFETY
1. READ AND UNDERSTAND all
safety instructions and operating
procedures throughout the manual.
2. DO NOT OPERATE the Scroll Saw
until it is completely assembled
and installed according to the
instructions.
3. SHOULD any part of Scroll Saw
be missing, damaged, or fail in any
way, or any electrical component
fail to perform properly, shut off the
switch and remove the plug from
the power supply outlet. Replace
missing, damaged, or failed parts
before resuming operation.
4. IF YOU ARE NOT thoroughly
familiar with the operation of a
Scroll Saw, obtain advice from
your supervisor, instructor or other
qualified person.
5. SERIOUS INJURY could occur if
the tool tips over or you accidentally
hit the cutting tool. Do not store
anything above or near the tool.
6. AVOID INJURY from unexpected
saw movement. Place the saw on
a firm level surface where the saw
does not rock and bolt or clamp the
saw to its support.