Filter
Top Products
Fig. 8 Fig. 10
C D
C
\
\
2,
8,
4,
insert a 5/16-18 x 5/8" hex head screw (C) through
the exhaust flange, exhaust flange gasket and the
exhaust port flange, See figure 8,
Thread 5/16-18 flange hex nut (D) onto the 5/16=18
x 5/8" hex head screw, do not tighten completely,
See figure 8,
Repeat Steps 1,2, and 3 for the remaining hobs,
Tighten all hardware,
SUPPORT TUBE ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
A
1, Place support tube clamp (A) over lower support
tube holder (B), See figure 9,
2, insert the lower support tube (C) into the lower
support tube holder and tighten support tube clamp,
See figure 10,
3, Place support tube clamp over top of lower support
tube,
iNTAKE FUNNEL ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
B
A
\
1, Align the two hobs in the intake support brace (A)
with the two hobs in the intake funnel (B),
See figure 11,
11