Filter
Top Products
BLADE INSTALLATION AND REMOVAL
This saw is designed to use all 1/2-in. universal shank blades.
I ,_ WARNING: To prevent personal injury, ALWAYS disconnect the I
plug from power source BEFORE assembling parts, making adjustments
I
or changing blades.
To Install Blade (Figure 2)
1. Disconnect saw from power source.
2. If necessary, extend the adjustable/
pivoting shoe away from the blade
clamp for easier access.
3. Rotate the blade clamp collar
clockwise about 180 °.
4. Insert the blade through the
rubber cover until it stops,
then release the collar.
5. Pull up on blade to
ensure that it is locked in.
To Remove Blade
1. Disconnect saw from power source.
2. If necessary, extend the adjustable/
pivoting shoe away from the blade
clamp for easier access.
3. Rotate the blade clamp collar
clockwise about 180°.
4. Pull the blade out of the blade
clamp and release the collar.
ADJUSTING THE SLIDING /
PIVOTING SHOE (Figures 3 and 4)
The shoe slides in or out to adjust the
depth of cut to material being cut for
maximum control and longer blade life.
To Slide Shoe In or Out: (See Fig. 3)
1, Pull shoe release lever and slide
shoe out to desired cutting depth.
The shoe locks in 3 positions.
2. Push in lever to lock shoe
in desired position.
...2.1
_ting_ Blade
Blade Clamp Collar
Fig.3
Shoe _ ,_*_'_Y/J/
Release kever_
NOTE:The shoe also pivots to provide
maximum control against the surface being cut.
To Pivot Shoe: (See Fig. 4)
1. Firmly hold saw and then pivot shoe to desired position.
9