Filter
Top Products
SWITCH
See Figure 2.
To turn your light on and off, depress switch trigger.
SWITCH
TRIGGER
MULTI-POSITION
HEAD
Fig. 2
MULTI-POSITION HEAD
See Figure 2.
Your worklight has the feature of a multi-position head
that has positive stop clicks at each position. Rotate
head to the desired position as shown in the arrows in
figure 2.
SAFETY RULES FOR WORKUGHTS
WARNING: Do not operate flashlight or charger
near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes.
WARNING: Lens and bulb become hot during
use:
• During or immediately after use, don't lay
worklight flat on lens surface.
• Handle worklight with care around any
flammable surface.
• If bulb has been lit, let worklight cool for
several minutes before changing bulb.
• Do not use or permit use of worklight in bed
or sleeping bags. A burn injury could result.
BULB REPLACEMENT
See Figure 3.
When purchasing replacement xenon bulb, request
recommended part number 981258-001,
TO REPLACE BULB:
• Remove battery pack from workiight.
• Remove the two screws securing lens cover, then
remove cover.
• Remove old bulb from spring.
• Position new xenon bulb in spring.
• Replace lens cover and screws.
• Replace battery pack.
Note: For your convenience, a bulb storage area with
extra bulb has been provided. It is located behind the
lens cover. See Figure 3.
SCREWS
BULB
BULB
STORAGE
AREA
LENSCOVER Fig. 3
To preserve natural resources, please
recycle or dispose of properly.
This product contains nickel-
cadmium batteries. Local, state or
federal laws may prohibit disposal of
nickel-cadmium batteries in ordinary
trash.
Consult your local waste authority for information
regarding available recycling and/or disposal options.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
USA
972000-671
5-99
For replacement parts information and ordering, call
this toll free number:
1-eo0-366-PART (1-800-366-7278)