Filter
Top Products
SWITCH TRIGGER
See Figure4.
To turn the Jightonand off, depress theswitch trigger.
SWITCH
Fig. 4
HANGING/STORAGE HOOK
See Figure5.
On top of the housing is a hook which you can use to
hang the light, This is good for storing the light when not
in use and keeping the light out of the reach of children.
Touse, simply lift up on the hook.
HANGING/
STORAGEHOOK
TO
RAISE
TO
LOWER,
Fig. 5
,_L WARNING: When servicing, use only identical
Craftsman replacement parts. Use of any other part
may create a hazard or causeproduct damage.
_L WARNING: Always wear safety goggles or safety
glasses with side shields when using compressed
air to clean worklights. If the operation is dusty, also
wear a dust mask.
_L WARNING: Toavoid serious personalinjury, always
remove the battery pack from the worklight when
cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
,_ WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products,penetrating
oils, etc. come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic which
may result inserious personal injury.
Only the parts shown in the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at a Sears Service Center.
12