Filter
Top Products
WARNING: Lens and bulb become hot during
use. Let worklight cool for several minutes after use
before changing bulb to prevent possibility of a burn
injury.
FLUORESCENT TUBE REPLACEMENT
See Figure6.
When purchasingreplacementfluorescent tube, request
replacement part number 7819602.
TO REPLACE FLUORESCENT TUBE:
• Removethe battery packfromthe worklight.
• Removethe screw to release the lenscover. Remove
the lens cover by pulling the coverforward and liftingit
from the housing.
• To remove the old fluorescent tube from the spring,
gently grasp the lower edge of the rubber cushion
and the sides of the bulb. Carefully work the tube in a
side-to-side motion while easing the tube forward and
up until the tube is free from the spring. Do not pull
the fluorescent tube straight out from its center,as this
increases the chance of breakage. Remove the rubber
cushion from the old fluorescent tube and place it on
top of the new tube, rounded edge facing outward.
Insert the new fluorescent tube into the spring by
aligning the prongs on the tube with the holes inthe
tube socket area.Gently push down on the base of the
new tube until fully engaged. Do not force the tube into
place.
• Replace the lens cover by sliding the lower edge
into the housing. Align the screw holes at top. With
a screwdriver, tighten the screw. Do not use a drill to
tighten the screw, as the drill's torque may be strong
enough to damage the lens cover.
• Replace the battery pack.
PULLLENSCOVER
FORWARDTO RUBBER
REMOVE CUSHION
SCREW
\
LENSCOVER
FLUORESCENTTUBE
(PARTNO,7819602)
BULBSOCKET
AREA Fig. 6
13