Filter
Top Products
BEFORE LEAVING THE SAW
See Figure 17.
[] Wait until the saw has come to a full and complete
stop.
[] Place the switch in the OFF position, remove the switch
key from the switch assembly. Store key in a safe
place.
[] Unplug the saw from the power source.
[] Make workshop childproof.
[] Lock the shop.
LOCKING THE SWITCH
See Figure 17.
[] Wait until the saw has come to a full and complete
stop.
/
SWITCH
KEY
Fig. 17
[] Place the switch in the OFF position, remove the switch
key from the switch assembly. Store key in a safe
place.
TiLTiNG THE TABLE
See Figure 18.
[] Loosen the table lock handle slightly.
[] Turn the angle adjustment knob, tilting the saw table
toward the front of the saw housing unti! it reaches the
desired angle.
[] Using the scale indicator, check angle markings.
[] Retighten the table lock handle to hold saw table securely
in place.
Fig. 18
USING THE MITER GAUGE
See Figure 19.
The miter gauge can be turned 45 ° to the right or left.
[] Loosen the lock knob on the miter gauge.
[] With the miter gauge in the miter gauge slot, rotate the
gauge unti! the desired angle is reached on the index
scale.
[] Retighten the lock knob.
LOCK
KNOB
MITER
GAUGE
8LOT
MITEB
GAUGE
2O
Fig. 19