Filter
Top Products
INSTALLING THE REAR RAIL
A'_ WARNING: Front and rear rails must be
carefully aligned to reduce the risk of kickback,
which can cause serious injury.
• From the carton, remove the rear rail and the
following hardware:
Right and left end caps for rear rail
2 screws (5/32-32 x 1/2 in.) for end caps
Note: The square head bolts, washers, and hex nuts
shown at the top of figure 3 should still be on the
table saw. If you mistakenly removed them, put
them back on the table. Do not tighten.
• Carefully slide the rail onto the square head bolts.
SQUAREHEAD
BOLT
HEXNUT
FLAT WASHER
• Position rail so that the right hand edge extends
2-1/2 in. beyond the table extension.
Note: Instructions are given from the operator's
position in front of the saw.
• Push the rail against table and tighten each hex
nut with a 12 mm wrench. If the rail jams or does
not slide easily over the bolts, re-align the table
extensions according to the instructions in the table
saw owner's manual.
Note: Make sure there are no gaps between the rail
and edge of table or extensions.
• Put the end caps on the rail ends. Insert the
screws and tighten with a phillips screwdriver.
SCREW
Fig. 4
4