Filter
Top Products
13 - ENG
N014212
Whentheair
compressor is operating, the check
valve is "open", allowing compressed
airtoentertheairtank.Whenthe
air compressor reaches "cut-out"
pressure, the check valve "closes",
allowing air pressure to remain inside
the air tank.
The motor has an automatic
reset thermal overload protector. If
the motor overheats for any reason,
the overload protector will shut off the
motor. The motor must be allowed
to cool down before restarting. The
compressor will automatically restart
after the motor cools.
1. Set the On/Off switch to "Off" .
unit until you read
maintenance instructions.
This procedure is required the
air compressor is put into service and
when the check valve or a complete
compressor pump has been replaced.
1. Make sure the On/Off switch is in
the "Off" position.
2.
Plug the power cord into the
correct branch circuit receptacle.
(Refer to
Protection paragraph in
the Installation section of
this manual.)
3. Open the drain valve (counter-
clockwise) fully to permit air to
escape and prevent air pressure
build up in the air tank during the
break-in period.
4. Move the On/Off switch to "On"
position. The compressor will start.
5. Run the compressor for 15 min-
utes. Make sure the drain valve
is open and there is minimal air
pressure build-up in tank.
6. After 15 minutes, close the drain
valve by turning clockwise. The
air receiver will fill to "cut-out"
pressure and the motor will stop.
The compressor is now ready for use.
1. Set the On/Off switch to "Off".
2. Turn the regulator knob counter-
clockwise to set the outlet
pressure to zero.
3. Attach hose and accessories.
The hose or accessory will
require a quick connect plug if the air
outlet is equipped with a quick con-
nect socket.
contain wa ter condensation and
by moisture. Some air tools and
tools and accessories.