Filter
Top Products
10- ENG
A14411
Assemble Wheels
It will be neces-
sary to brace or
support one side of the outfit when
installing the wheels because the
compressor will have a tendency
to tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
2. Tighten securely. NOTE: The out-
fit will sit level if the wheels are
properly installed.
The wheels and
handle do not
provide adequate clearance, stabil-
ity or support for pulling the unit
up and down stairs or steps. The
unit must be lifted, or pushed up a
ramp.
Assemble Rubber Feet
1. Attach rubber feet with the
screws provided as shown in
previous figure.
2. Tighten securely.
Rubber
Feet
Screw
Nut
Wheel
Shoulder
Bolt
ASSEMBLY
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1. Remove all packaging leaving
the air compressor on the pallet.
2. Remove and discard the (4)
screws holding the air compres
-
sor to the pallet.
It may be neces
-
sary to brace or
support one side of the air com
-
pressor when removing the pallet
because the air compressor will
have a tendency to tip.
3. Carefully remove the air com
-
pressor from the pallet.
Screws
Contents of Carton
1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20 x .75"