Filter
Top Products
REVERSIBLE
See Figure 3.
This tool has the feature of being reversible. The
direction of rotation is controlled by a selector located
above the switch trigger. With the drill held in normal
operating position, the direction of rotation selector
should be positioned to the left of the switch for
drilling.The drilling direction is reversed when the
selector isto the rightof the switch. When the selector
is in center position, the switch trigger is locked.
SELECTOR
CENTERPosmoN REVERSE
(LOCK)
TRIGGER FORWARD
Fig. 3
CAUTION: To prevent gear damage, always
allow chuck to come to a complete stop before
changing the direction of rotation.
To stop, release switch tdgger and allow the chuck to
come to a complete stop.
TO INSTALL BA'I-FERY PACK
See Figure 4.
• Lock switch tdgger on your drill by placing the
direction of rotation selector in center position.
See Figure ?.
• Place battery pack in your ddll. Align raised db
inside drill with groove on battery pack.
See Figure 4.
BATTERYP/_CK t
LATCHES
RELEASEBATTERYPACK Fig. 4
Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
CAUTION: When placing battery pack in your
ddll, be sure raised rib inside ddll aligns with
groove on battery pack and latches snap into
place properly. Improper assembly of battery
pack can cause damage to internal components.
TO REMOVE BATTERY PACK
• Lock switch trigger on your drillby placing the
direction of rotation selector in center position.
See Figure 2.
• Locate latches on end of battery pack and
depress to release battery pack from your ddll.
See Figure 4.
• Remove battery pack from your drill.
8