Filter
Top Products
5
CLEANING
Remove the protective coating from the machined surfaces of the drill press and all loose items. This coating may be
removed with a soft cloth moistened with kerosene. DO NOT use acetone, gasoline, or lacquer thinner for this purpose.
ASSEMBLING THE DRILL PRESS
Fig. 3
1. Assemble the column (A) Fig. 3, to the base (B) using
the four screws, three of which are shown at(C). Loosen
set screw (D) and remove ring (E) and raising rack (F).
Fig. 4
Fig. 5
2. Make certain worm gear (G) Figs. 4 and 5, is in place
in table bracket (H) as shown.
Fig. 6
3. Insert raising rack (F) Fig. 6, which was removed in
STEP 1, into groove in table bracket making sure teeth
of worm gear (G) located inside table bracket are
engaged with teeth of raising rack (F).
G
H
H
G
F
G
A
B
C
C
F
E
D