Filter
Top Products
17
CHANGING BAND SAW FROM
HORIZONTAL TO VERTICAL
POSITION
Your saw can be changed to the vertical position for
notching, slitting or contour work as follows:
DISCONNECT MACHINE FROM
POWER SOURCE.
1. Move the cutting arm to the vertical position and
lock in place with the arm positioning lever (C) Fig. 32.
Stop screw (A) Fig. 32 should bear against base casting
when arm is in the vertical position. If adjustment is
needed loosen lock nut (B) and adjust screw (A).
2. Remove two screws (C) and bearing cover plate (D)
Fig. 33.
3. Assemble the vertical table (E) to the guide bracket
using the two screws (C) that were removed in STEP 2,
as shown in Fig. 34.
4. Assemble one end of the table support bracket (G)
Fig. 35 to the table using a 1/4-20x1/2" flat head screw
and 1/4-20 nut (H) and the other end underneath the
guide bracket lock knob (J), as shown in Fig. 35.
Fig. 32
Fig. 33
Fig. 34
Fig. 35
B
A
D
C
C
E
C
J
G
H
C