Delta 23-198 Grinder User Manual


 
13
1. Periodically blow out all air passages with dry
compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to
clean plastic parts. They could possibly dissolve or
otherwise damage the material.
2. Periodically inspect the tightness of the arbor nuts.
3. Periodically check tightness on all other hardware
and listen for any unusual vibrations as you work as
these may be a sign of loose hardware.
OTHER RECOMMENDED MAINTENANCE
FIGURE 9
REPLACING OR CHANGING GRINDING WHEELS
Disconnect the machine from the
power source.
For steps 1-4, refer to Figures 4 & 5 on page 10:
1. Remove the thumb screws securing the outer face
of the wheel guard to the tool frame.
2. Rotate the wheel guard to free it from the retaining
screws and remove guard.
3. Raise both wings of the arbor nut.
4. Firmly grasp the wings of the arbor nut with one
hand while using the other hand to keep the wheel
from moving. Loosen the arbor nut.
NOTE: You may also use the 13mm flat wrench
(provided) positioned on the flat of the arbor shaft,
(located between left side wheel and motor) to keep
the shaft steady as you tighten the arbor nut.
NOTE: To loosen the arbor nut on the right side rotate
it counterclockwise. To loosen the arbor nut on the left
side rotate it clockwise.
5. Remove the arbor nut (A), wheel flange (B), and old
grinding wheel (C), as shown in Figure 10.
6. Place the new grinding wheel on the arbor.
NOTE: Grinding wheels for the 23-198 must be ¾"
wide while grinding wheels for the 23-199 must be 1"
wide.
MAINTENANCE
7. Place the flange on the arbor and thread the arbor
nut on the arbor until the arbor nut makes contact
with the arbor flange.
8. Tighten the arbor nut as tight as you can by hand.
9. Push the arbor nut wings out and down to the
closed position so that they lay flat against the thick
wheel flange.
10. Replace the wheel guard and secure with thumb
screws.