Filter
Top Products
3
ADDITIONAL SAFETY RULES FOR GRINDERS
1. DO NOT OPERATE your tool until it is completely
assembled and installed according to the instructions.
2. IF YOU ARE NOT thoroughly familiar with the oper-
ation of grinders, obtain advice from your supervisor,
instructor or other qualified person.
3. USE only attachments rated for 3600 RPM or higher
with a 1/2" arbor hole. NEVER use an attachment rated
lower than 3600 RPM or attempt to machine an
undersized attachment to fit an arbor.
4. NEVER use a chipped or cracked wheel. ALWAYS
inspect each wheel before mounting on the grinder.
REPLACE A CRACKED WHEEL IMMEDIATELY.
5. DO NOT overtighten wheel nut.
6. ALWAYS maintain a distance of 1/8" or less between
the wheel and the tool rest. Adjust the tool rests as the
wheels decrease in size with use.
7. SECURELY tighten tool rests so they cannot shift
position while in use.
8. NEVER grind on a cold wheel. The grinder should
always be started and run at idle speed for one full
minute before applying work.
9. NEVER grind on the side of the wheel. ALWAYS
grind on the face of the wheel only.
10. NEVER apply coolant directly to a grinding wheel.
Coolant can weaken the bonding strength of the wheel
and cause it to fail. Dip the workpiece into water to cool
it.
11. SPARKS ARE A HAZARD! NEVER operate tool near
flammable gas or liquids.
12. ALWAYS MAKE SURE the wheel guards and eye
shields are in place, properly adjusted and secured.
13. KEEP the spark guards close to the wheel and re-
adjust them as the wheel wears.
14. MAKE CERTAIN the blotter and flanges furn-
ished with the grinder are used to mount the
attachments (grinding wheels, wire brushes, buffing
wheels, etc.) onto the shaft.
15. STAND to one side of the grinder when turning on
the power.
16. AVOID awkward hand positions where a sudden slip
could cause a hand to move into the attachment
(grinding wheel, wire brush, buffing wheel, etc.).
17. ALWAYS keep hands and fingers away from the
attachments (grinding wheel, wire brush, buffing wheel,
etc.).
18. NEVER start the grinder with the workpiece pressed
against the attachment (grinding wheel, wire brush,
buffing wheel, etc.).
19. DRESS the wheel on the face only. Dressing the side
of the wheel can cause it to become too thin for safe use.
20. DO NOT use an attachment that causes vibration.
Dress the grinding wheel, replace the wheel or other
attachment, or replace the shaft bearings, if worn.
21. GRINDING CREATES HEAT. Do not touch the
work-piece until you are sure it has cooled sufficiently.
22. SHOULD any part of your tool be missing, damaged,
or fail in any way, or any electrical component fail to
perform properly, shut off switch and remove plug from
power supply outlet. Replace missing, damaged or failed
parts before resuming operation.
23. ADDITIONAL information regarding the safe and
proper operation of this product is available from the
National Safety Council, 1121 Spring Lake Drive, Itasca,
IL 60143-3201 in the Accident Prevention Manual for
Industrial Operations and also in the Safety Data Sheets
provided by the NSC. Please also refer to the American
National Standards Institute ANSI B7.1 Safety
Requirements for the use, care, and protection of
abrasive wheels; ANSI B11.9 Safety Requirements for
the construction, care and use of grinding machines; and
the U.S. Department of Labor OSHA 1910.215
Regulations for Abrasive Wheel Machinery.