Filter
Top Products
7
Fig. 6
Fig. 7
D
C
C
D
Fig. 9
AA
Fig. 8
B
ASSEMBLING EYE SHIELDS
Your grinder is supplied with two eye shields for operator protection. NOTE: ALWAYS WEAR EYE PROTECTION.
To assemble the eye shields, proceed as follows:
1. Assemble long end of eye shield mounting rod (D) Fig. 1, to the side of each wheel guard using the eye shield rod
bracket (E) Fig. 1, and screw (3) Fig. 2, and washer (8) Fig. 2. Note: The mounting rod should be positioned so that the
“L” shaped end of the mounting rod is pointing outward, away from the machine. Fig. 7.
2. Insert the “L” shaped end of mounting rod (D) Fig. 7, into hole of frame (C) Fig. 7 and fasten in place with screw
(6) Fig. 2, one washer (9) Fig. 2, and one nut (10) Fig. 2. The eye shield (C) is fully adjustable so it can be put in any
position by moving the shield (C) or loosening screw (3) Fig. 2 and repositioning rod (D).
3. Assemble the remaining eye shield to other wheel guard in the same manner.
ASSEMBLING WATER TRAY
To assemble the water tray (B) Fig. 8, align holes in the
water tray, with the holes in the front of the grinder, insert
two screws (5) Fig. 2, and tighten securely.
FASTENING GRINDER
TO SUPPORTING SURFACE
(MODEL 23-725)
IF DURING OPERATION THERE IS ANY TENDENCY
FOR THE GRINDER TO TIP OVER, SLIDE OR “WALK”
THE GRINDER MUST BE SECURED TO A SUPPOR-
TING SURFACE, SUCH AS A WORK BENCH,
THROUGH THE HOLES (A) FIG. 9, IN THE GRINDER
BASE.