Delta 34-814 Saw User Manual


 
25
TROUBLESHOOTING
For assistance with your machine, visit our website at www
.deltamachinery.com
for a list of service centers or call
the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
MAINTENANCE
NOTE: Two wrenches are supplied with the saw for
changing the saw blade: a box-end wrench and open-
end wrench.
1. Remove table insert (C) Fig. 53, and raise saw blade
to its maximum height.
2. Place the open end wrench (B) Fig. 53 on the flats of
the saw arbor to keep the arbor from turning, and
use wrench (A), to turn the arbor nut toward the front
of the saw. Remove arbor nut, blade flange, and saw
blade.
3. Attach the new blade, making certain the teeth point
down at the front of the saw table, and assemble
outside blade flange and arbor nut. With wrench (B)
Fig. 53, on the flats of the arbor to keep it from turning, tighten arbor nut by turning wrench (A) Fig. 54
counterclockwise toward the rear of the saw.
5. Replace table insert. IMPORTANT: When installing the table insert, make certain to hold on to the blade guard.
NOTE: Use only 10" saw blades with 5/8" arbor holes, rated for at least 4000 RPM.
1. Open the motor cover door to gain access to the motor.
2. Place a block of wood (C) Fig. 70 between the motor and the saw cabinet.
NOTE: You may have to raise the saw arbor to insert the wooden block. Lower the saw arbor until the motor contacts
the wood.
3. Loosen the bolt (D) Fig. 70 and continue to lower the saw arbor until all tension is removed from the belts (E). Tighten
the bolt (D).
4. Raise the saw arbor slightly and remove the block of wood (C) Fig. 70.
5. Lower the saw arbor. Remove the belts (E) Fig. 71, one at a time from the motor pulley.
6. Remove the belts (E) Fig. 71 one at a time from the arbor pulley (F).
7. Install the three new belts, one at a time in the grooves of the arbor pulley (F) Fig. 71, and on the motor pulley.
8. When the new belts are installed, loosen the screw (D) Fig. 70, and carefully let the motor rest on the belts.
9. The correct belt tension shows approximately 1/4" deflection in the center span of the pulleys, using light finger
pressure.
10. Tighten the screw (D) Fig. 70.
CHANGING THE SAW BLADE
DISCONNECT MACHINE FROM POWER SOURCE!
REPLACING BELTS AND ADJUSTING BELT TENSION
Fig. 69
Fig. 70
Fig. 71
B
C
A
C
D
E
F
E
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:45 PM Page 25