Filter
Top Products
9
5. With the teeth of the blade fac-
ing away from the saw, insert the
blade through the blade guide (G)
Fig. 8, into the blade holder (H) as far
as it will go and tighten the two
screws (F) Fig. 7.
6. Lower the blade guard (A) Fig.
5, by pushing down on tab (B).
7. Install battery pack.
Fig. 8
AVOID CONTACT
WITH THE BLADE TEETH TO
PREVENT PERSONAL INJURY.
BLADE REMOVAL
Follow the blade installation proce-
dure and remove the blade instead
of installing the blade.
SAW OPERATION
TO START AND STOP SAW
THIS TOOL IS
ALWAYS IN AN OPERATING CON-
DITION BECAUSE IT DOES NOT
HAVE TO BE PLUGGED INTO AN
ELECTRICAL OUTLET. KEEP
HANDS, BODY, AND CLOTHING
CLEAR OF THE BLADE WHEN A
BATTERY PACK IS INSTALLED IN
THE SAW.
1. Install battery pack.
2. Hold down button (A) Fig. 9
from either side of handle (B).
3. Squeeze power trigger (C) Fig. 9
to start the blade in motion.
4. Release power trigger (C) Fig. 9
to stop the blade.
Fig. 9
VARIABLE SPEED
This saw is equipped with a variable speed control switch. The speed range is
0 to 2700 SPM. The speed is adjusted by squeezing the power trigger. The more
the power trigger is squeezed the higher the speed.
Use higher speed for fast cutting when finish and accuracy are not critical.
Use slower speed when accuracy and finish are critical or for delicate materi-
als.
G
H
A
B
C