Filter
Top Products
16
Fig. 39 Fig. 39A
PUSH BLOCKS
A set of push blocks (A) Fig. 37, is supplied with your
jointer and should be used whenever possible to
minimize all danger to your hands. Fig. 37, illustrates
using the push blocks properly.
JOINTING AN EDGE
This is the most common operation for the jointer. Set the guide fence square with the table.
Depth of cut should be the minimum required to obtain a straight edge. Hold the best face of the
piece firmly against the fence throughout the feed as shown in Fig. 39.
DO NOT PERFORM JOINTING OPERATIONS ON MATERIAL SHORTER THAN 10 INCHES,
NARROWER THAN 3/4 INCH, OR LESS THAN 1/2 INCH THICK (REFER TO FIG. 39A).
OPERATION
The following directions will give the beginner a start on jointer operations. Use scrap pieces of lumber to check the
settings and to get the feel of the operations before attempting regular work.
WARNING: ALWAYS USE CUTTERHEAD GUARD AND KEEP HANDS AWAY FROM CUTTERHEAD. USE
PUSH BLOCKS WHENEVER POSSIBLE.
PLACEMENT OF HANDS
DURING FEEDING
At the start of the cut, the left hand holds the work firmly
against the infeed table and fence, while the right hand
pushes the work toward the knives. After the cut is un-
derway, the new surface rests firmly on the outfeed table
as shown in Fig. 38. The left hand should then be moved
to the work on the outfeed table, at the same time
maintaining flat contact with the fence. The right hand
presses the work forward, and before the right hand
reaches the cutterhead it should be moved to the work
on the outfeed table. CAUTION: NEVER PASS HANDS
DIRECTLY OVER THE CUTTERHEAD.
Fig. 38
OUT-FEED
TABLE
IN-FEED TABLE
CUTTER
3/4" MINIMUM
10" MINIMUM
MINIMUM JOINTING DIMENSIONS
1/2"
MINIMUM
Fig. 37
A
MATERIAL