Filter
Top Products
6
Fig. 9
Fig. 10
Fig. 11
Fig. 12
4. Apply a bead of silicone sealant around flange of
chute (F) Fig. 9. Align holes in ten-hole gasket (G) Fig. 9,
with mounting holes in blower flange (F) and press
gasket onto flange as shown.
5. Align mounting holes in dust chute (H) Fig. 10, with
gasket (G), assembled in STEP 4. Place a lockwasher
onto a hex head screw, insert screw through the chute
and gasket, thread the screw into the motor assembly,
and tighten securely. Repeat this process for the 9
remaining holes. Fig. 11 shows the dust chute
assembled to the motor assembly.
F
G
G
H
M
R
L
P
6. Align the two holes in “U” bracket (L) Fig. 12, with
two pre-drilled holes (M) in left hand drum. Place a
lockwasher (R), then a flat washer (S) onto the hex head
screw (P). Insert the hex head screw through the hole in
the “U” bracket and the hole in the drum, thread the hex
nut (T) onto the hex head screw and tighten securely as
shown in Fig. 13. Repeat this process for the remaining
hole. Assemble the remaining “U” bracket to right hand
drum in the same manner.
S
T