Filter
Top Products
7
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes less than 1/2 hour.
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
3/16" Hex Wrench (Supplied)
1/2" Socket Wrench (Supplied)
7/16' open-end wrench
1. Carefully turn the machine upside down. Place it on a clean, firm, supporting surface.
2. Use a flat-head screwdriver or similar device to remove the plug (A) Fig. 1 to gain access to socket-head screw
(not shown).
3. Carefully place the machine on its side (Fig. 2). Attach the spindle adapter (B) Fig. 2 to the motor shaft (A) by
turning the spindle adapter counter-clockwise on the shaft.
NOTE: Motor shaft has a left-hand thread.
4. Place a 7/16" open-end wrench (D) Fig. 3 (not sup plied) on the flats of spindle adapter (B). Insert a 3/16" hex
wrench (E) Fig. 3 (supplied) into the socket-head screw located where the plug (A) Fig. 1 was removed in STEP 2.
5. Hold the hex wrench (E) Fig. 4 to prevent the motor shaft from turning. Turn the wrench (D) coun ter -clock wise to
fasten the spindle adapter on the motor shaft.
6. Install the plug (A) Fig. 1 that was removed in STEP 2.
A
A
B
D
E
D
FIG. 1
FIG. 2
FIG. 3
FIG. 4
B