Filter
Top Products
10
The depth to which a fastener is driven is controlled by the depth adjustment
knob (A) Fig. 25. The depth of drive is factory adjusted to a nominal setting.
Test fire a fastener and check depth. If a change is desired, rotate the
adjustment knob (A) Fig. 25. The adjustment knob has detents every
1
/4
turn.
Rotate the knob (A) Fig. 25 clockwise to increase the depth of drive, rotate
the knob counterclockwise to decrease the depth of drive. Test fire another
fastener and check depth. Repeat as necessary to achieve desired results.
The amount of air pressure required will vary depending on the size of the
fastener and the material being fastened. Experiment with the air pressure
setting to determine the lowest setting that will consistently perform the job
at hand. Air pressure in excess of that required can cause premature wear
and/or damage to the tool.
RUBBER NOSE CUSHION
A rubber nose cushion (A) Fig. 26 is provided to reduce marring of the work
surface. The rubber cushion can be removed, and stored inside the
magazine (B) Fig. 27 when it is not required.
Disconnect tool from air supply before removing or re-
installing rubber cushion.
Fig. 27
A
Fig. 25
A
B
Fig. 26